LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 484 (Automatic Transaxle Diagnosis, Service & Repair - 4T65-E) >> Repair Instructions >> Automatic Transmission Mount Bracket Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Remove the left front tire and wheel.
  3. Remove the left engine splash shield. Refer to SPLASH SHIELD REPLACEMENT -- ENGINE .
  4. Use a utility stand with a block of wood in order to support the transaxle.
  5. Remove the transaxle mount upper nuts.
    Fig 1: Removing Transaxle Mount Upper Nuts
    G01502053Courtesy of GENERAL MOTORS CORP.
  6. Remove the transaxle mount bracket bolts.
  7. Remove the transaxle mount bracket.
    Fig 2: Removing Transaxle Mount Bracket Bolts
    G01502054Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals