LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 479 (HVAC Systems - Automatic) >> Repair Instructions >> Mode Actuator Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the knee bolster from the instrument panel (I/P). Refer to KNEE BOLSTER REPLACEMENT .
  2. Disconnect the mode actuator electrical connector.

    Important:  Count the number of threads showing from the tip of the mode actuator push rod to the end of the retainer clip.

  3. Open the mode actuator push rod retainer clip (1) with a small flat-bladed screwdriver.
  4. Disconnect the mode actuator push rod (2) from the retainer clip (1).
    Fig 1: Disconnecting Mode Actuator Push Rod From Retainer Clip
    G01499275Courtesy of GENERAL MOTORS CORP.

    Important:  Disconnect the I/P wiring harness clip from the I/P support bracket to help access the mode actuator screws.

  5. Disconnect the I/P wiring harness clip from the I/P support bracket.
  6. Remove the mode actuator mounting screws.
  7. Remove the mode door actuator.
    Fig 2: Removing Mode Actuator Mounting Screws
    G01499276Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals