LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 475 (Stationary Window System) >> Repair Instructions >> Window Replacement - Lift Gate (Pontiac) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a stationary window into the opening. Refer to URETHANE ADHESIVE INSTALLATION OF STATIONARY WINDOWS  .
  2. Install the liftgate window and frame to the vehicle. Refer to LIFT GATE REPLACEMENT (AZTEC) or LATCH REPLACEMENT -- LIFT GATE (RENDEZVOUS) .
  3. Install the rear spoiler. Refer to SPOILER REPLACEMENT -- REAR .
  4. Install the liftgate trim. Refer to TRIM PANEL REPLACEMENT -- LIFT GATE (AZTEC) or TRIM PANEL REPLACEMENT -- LIFT GATE (RENDEZVOUS) .
  5. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
  6. Close the liftgate.
    Fig 1: Closing Liftgate
    G01515729Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals