LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 474 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Front Wheel Opening (Rendezvous) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the wheel opening molding retainers to the molding, if removed.
    Fig 1: Installing Wheel Opening Molding Retainers
    G01515606Courtesy of GENERAL MOTORS CORP.
  2. Position the front wheel opening molding to the fender.
  3. Align the push-in retainers to the holes in the fender.
  4. Press the front wheel opening molding to the fender until all of the retainers are fully seated.
    Fig 2: Positioning Front Wheel Opening Molding To Fender
    G01515607Courtesy of GENERAL MOTORS CORP.
  5. Install the front wheel opening molding screws to the front wheel opening molding.

    Tighten 

    Tighten the screws to 2 N.m (18 lb in).

    Fig 3: Installing Front Wheel Opening Molding Screws
    G01515608Courtesy of GENERAL MOTORS CORP.
  6. Press the corner of the front fascia to the fender to seat the retainer.
  7. Install the screws to the corner of the front fascia.

    Tighten 

    Tighten the screws to 2 N.m (18 lb in).

    Fig 4: Pressing Corner Of Front Fascia
    G01515609Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals