LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 474 (Exterior Trim) >> Repair Instructions >> Emblem Replacement - Hood >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply masking tape to the area around the hood emblem to protect the finish.
  2. Open the hood.
  3. Remove the nuts from the back of the hood emblem.
  4. To remove the emblem from the hood, heat the emblem using the J 25070  152 mm (6.0 in) from the surface.
  5. Apply heat in a circular motion for about 30 seconds.
    Fig 1: Removing Nuts From Back Of Hood Emblem
    G01515595Courtesy of GENERAL MOTORS CORP.
  6. Use a plastic, flat bladed tool to lift or remove the emblem from the hood.
  7. Remove any adhesive from the hood using a 3M™ Scotch Brite molding adhesive remover disk P/N 07501 or equivalent.
    Fig 2: Removing Adhesive From Hood
    G01515596Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals