LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 472 (Steering Wheel & Steering Column) >> Repair Instructions >> Ignition Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
  2. Remove the steering column trim covers. Refer to STEERING COLUMN TRIM COVERS REPLACEMENT  .
  3. Pull the theft deterrent control module (2) away from the lock cylinder housing (1).
    Fig 1: Removing Theft Deterrent Control Module Away From Lock Cylinder Housing
    G01499421Courtesy of GENERAL MOTORS CORP.
  4. Depress the 2 white spring loaded retainers on the ignition switch.
  5. Slide the ignition switch downward away from the ignition lock cylinder case.
  6. Disconnect the electrical connector from the ignition switch.
    Fig 2: Disconnecting Electrical Connector From Ignition Switch
    G01499422Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals