LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 463 (Bumper System) >> Repair Instructions >> Fascia Replacement - Front Bumper (Luxury Y91) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  1. Install the bolts that retain the front fascia mounting brackets to the bumper, if removed.

    Tighten 

    Tighten the front fascia mounting bracket to bumper bolts to 2 N.m (18 lb in).

  2. Install the front fascia support (2) to the bumper, if removed. Tap down on the support with a rubber mallet, in order to install the tabs into the bumper.
  3. Install the push pin retainers (1) to the top of the front fascia.
  4. Install the bolts that retain the front fascia (4) to the mounting bracket (3).

    Tighten 

    Tighten the front fascia to mounting bracket bolts to 2 N.m (18 lb in).

  5. Install the front grille to the vehicle. Refer to GRILLE REPLACEMENT .
    Fig 1: Installing Front Fascia Support
    G01736828Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals