LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 461 (Body Front End) >> Repair Instructions >> Hood Latch Release Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the hood.
  2. Remove the cable (1) from the hood latch (3).
    Fig 1: Removing Cable From Hood Latch
    G01736863Courtesy of GENERAL MOTORS CORP.
  3. Remove the cable (1) from the retainer on the radiator support.
  4. Push the cable (1) and the grommet into the cab from the engine compartment.
  5. Remove the left side hinge pillar trim panel from the body. Refer to TRIM REPLACEMENT - HINGE PILLAR .
  6. Remove the screws retaining the cable handle (3) to the body.
  7. Remove the handle (3) from the hinge pillar.
  8. Remove the cable (1) from the vehicle.
    Fig 2: Removing Cable & Handle
    G01736864Courtesy of GENERAL MOTORS CORP.