LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 459 (Exterior Trim) >> Repair Instructions >> Emblem/Nameplate Replacement - Rear Bumper Fascia >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. When replacing or repairing an emblem/nameplate do the following:
    1. 1.1. Use tape to protect the mounting surface during removal.
    2. 1.2. Use tape for alignment marks for installation of the emblem/nameplate.
  2. Heat the emblem/nameplate using an J 25070. 

    Apply heat using a circular motion for about 30 seconds.

    NOTE: Use a plastic, flat-bladed tool to prevent paint damage when removing an emblem/name plate.
  3. Use a plastic, flat-bladed tool to remove the emblem/nameplate from the panel surface.
  4. When replacing, remove all adhesive as follows:
    • For body panels use a 3M™ Scotch Brite molding adhesive remover disk 3M™ P/N 07502 or equivalent.
      • Fig 1: Identifying 3M™ Scotch Brite Molding Adhesive Remover Disk
      G01755506Courtesy of GENERAL MOTORS CORP.
    • For plastic panels use a lint-free cloth and Varnish Makers and Painters (VMP) naphtha or a 50/50 mixture by volume of isopropyl alcohol and water to remove the adhesive.
scientia non olet · About LEMON Manuals