Installation Procedure

Important:  Apply the nameplate in an environment that is free from dust or other dirt that could come into contact with the sticky backing. Foreign material may cause improper adhesion.

1. Ensure the area where the nameplate will be installed is clean and dry.
2. If the location of the nameplate has not been marked, apply tape and use the following dimensions for the BUICK door nameplate.
   • Dimension (A) 30 mm (1.188 in) from the top of the molding to the bottom of the nameplate.
   • Dimension (B) 80 mm (3.156 in) from the front edge of the door to the beginning of the nameplate.
     Fig 1: Identifying BUICK Emblem Location

     Courtesy of GENERAL MOTORS CORP.
3. If the location of the nameplate has not been marked, apply tape and use the following dimensions for the Regal door nameplate.
   • Dimension (A) 30 mm (1.188 in) from the top of the molding to the bottom of the nameplate.
   • Dimension (B) 80 mm (3.156 in) from the front edge of the door to the beginning of the nameplate.
     Fig 2: Identifying Regal Emblem Location

     Courtesy of GENERAL MOTORS CORP.
4. For the Century LIMITED nameplate apply to the recessed area in the door molding as shown.
Fig 3: Identifying Century LIMITED Emblem Location
Courtesy of GENERAL MOTORS CORP.
5. Heat the mounting surface to approximately 27-41°C (80-105°F) using the J 25070  , if necessary.
6. Ensure that the temperature of the nameplate is approximately 29-32°C (85-90°F).

   Important:  Do not touch the adhesive backing on the nameplate.

7. Remove the protective liner from the back of the nameplate.
8. Position the nameplate to the location marks and press the nameplate to the mounting surface.
9. Apply equal pressure along the nameplate uniformly bond the item to the mounting surface.
10. Remove the protective tape from the mounting surface.