LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 455 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rocker Panel >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the molding retainers to the holes in the rocker panel and snap the molding (2) into place.
  2. Ensure the clips are fully engaged in the lower side frame.
  3. Close the doors and check the molding for proper fit.
    Fig 1: Installing Rocker Panel Molding
    G01803207Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals