Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.

If the location of the emblem/nameplate has not been marked apply tape and use the following dimensions:
- Dimension "A" is 70.0 mm (2.76 in) from the front edge of the hood.
- Dimension "B" is 43.5 mm (1.71 in) from the centerline of the hood (1).
Fig 1: Identifying Emblem/Nameplate Installation Position
Courtesy of GENERAL MOTORS CORP.
Warm the surface with a heat gun J 25070 152 mm (6 in) from the surface to a minimum of 21°C (70°F).

Fig 2: Heating Installation Position
Courtesy of GENERAL MOTORS CORP.

Important: Do not touch the adhesive backing of the emblem/nameplate.
Remove the backing from the front end of the emblem/nameplate.
Press the emblem/nameplate (1) to the hood surface while continuing to remove the backing.

Fig 3: Installing Emblem

Courtesy of GENERAL MOTORS CORP.

Hand roll the emblem/nameplate to the hood to ensure proper adhesion.
Inspect the emblem/nameplate for bonding.
Remove the tape from the area around the emblem.