LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 453 (Door System, Mirror System & Window System) >> Repair Instructions >> Sealing Strip Replacement - Rear Door Window Belt Inner >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora and 2001 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lower the window.
  2. Remove the door trim panel. Refer to Trim Panel Replacement - Side Rear Door .
  3. Starting at one end of the door window inner belt seal strip (1) pull upward in order to release the seal strip.
    Fig 1: Removing Window Inner Belt Seal Strip
    G01803640Courtesy of GENERAL MOTORS CORP.
  4. If further disassembly of the door is required, remove the auxiliary water deflector.
    1. 4.1. Gently remove folded portion of deflector from the door flange.
    2. 4.2. Lift deflector up and out of the door.
    Fig 2: Removing Auxiliary Water Deflector
    G01803641Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals