LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 451 (Body Front End) >> Repair Instructions >> Seal Replacement - Hood Rear Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the protective backing paper from the adhesive on the rear side hood seal.
  2. Install the rear side hood seal to the pinchweld flange and motor compartment flange.
    3. Fig 1: Identifying Hood Rear Side Seal
    G01755699Courtesy of GENERAL MOTORS CORP.
  3. Install the side rear hood seal onto the pinch-weld flange and motor compartment flange until the adhesive is fully adhered.
  4. Close the hood.
scientia non olet · About LEMON Manuals