LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 448 (Seat Belt System) >> Repair Instructions >> Seat Belt Retractor Replacement - Center Rear >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear seat cushion. Refer to SEAT CUSHION REPLACEMENT -- REAR .
  2. Remove the rear center shoulder belt anchor fastener.
    3. Fig 1: Removing Rear Center Shoulder Belt
    G01804202Courtesy of GENERAL MOTORS CORP.
  3. Remove the rear seat back. Refer to SEAT BACK REPLACEMENT -- REAR .
  4. Release the push-in retainers securing the rear shelf trim (1).
    Fig 2: Releasing Rear Shelf Trim Push-In Retainers
    G01804203Courtesy of GENERAL MOTORS CORP.
  5. Release the center shoulder belt escutcheon by prying upward on the front corner.
    Fig 3: Releasing Center Shoulder Belt Escutcheon
    G01804204Courtesy of GENERAL MOTORS CORP.
  6. Carefully lift up-ward on the rear shelf trim enough to expose the retractor fastener (2).
  7. Remove the fastener (2).
  8. Remove the rear compartment front trim panel. Refer to COMPARTMENT TRIM PANEL REPLACEMENT--REAR
  9. Remove the retractor through the rear compartment.
  10. Feed the center shoulder belt and escutcheon through the hole in the rear shelf trim panel.
    Fig 4: Removing Retractor Fastener
    G01804205Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals