Inflatable Restraint Steering Wheel Module Coil - Assemble - Off Vehicle
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
- Install the wave washer (1).
Important: Improper alignment of the inflatable restraint steering wheel module coil may damage unit causing an inflatable restraint malfunction.
- Align the block tooth on the steering shaft assembly (1) to the 12 o'clock position.
Important: A new inflatable restraint steering wheel module coil is pre-centered. Do not remove the centering tab from the new inflatable restraint steering wheel module coil until the installation is complete.
- If installing the existing inflatable restraint steering wheel module coil, it must be centered first. Refer to Inflatable Restraint Coil Centering - Off Vehicle (Column Shift And Floor Shift) .
- Align the inflatable restraint steering wheel module coil (2) with the horn tower sticking through the shaft lock shield assembly (1).
- Slide the inflatable restraint steering wheel module coil (2) onto the steering shaft assembly.
- Remove and discard the centering tab from the new inflatable restraint steering wheel module coil (2).
Important: Seat the retaining ring (1) securely on the groove of the race and upper shaft assembly (2).
- Install the retaining ring (1) using snap ring pliers.
- Install the black inflatable restraint steering wheel module coil connector to the fused jumper assembly connector.
Courtesy of GENERAL MOTORS CORP.
CAUTION: Refer to SIR INFLATOR MODULE COIL CAUTION . - Install the wire harness straps.
- Install the wire harness assembly into the wire restraint clip (1).
- Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle .
- Enable the inflatable restraint steering wheel module. Refer to ACTIVATING SYSTEM .