LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 445 (Bumpers) >> Repair Instructions >> Fascia Support Replacement - Front Bumper >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the front bumper fascia side supports to the front bumper fascia.
    Fig 1: Identifying Front Bumper Fascia Support
    G01755621Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  2. Install the front bumper fascia side support to radiator support bolts. Tighten the bolts to 10 N.m (88 in lbs).
  3. Install the bolts from the front bumper fascia side support to the bottom of the fender. Tighten the bolts to 10 N.m (88 in lbs).
  4. Install the front fender liners. Refer to FRONT FENDER LINER REPLACEMENT .
scientia non olet · About LEMON Manuals