LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 445 (Bumpers) >> Repair Instructions >> Fascia Bracket Replacement - Front Bumper >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the front bumper fascia center support bracket to the center support.
    Fig 1: Identifying Front Bumper Fascia Bracket
    G01755619Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  2. Install the bolts to the front bumper fascia lower center support bracket at the center support. Tighten the bolts to 10 N.m (88 in lbs).
  3. Install the bolts to the front bumper fascia upper center support bracket at the front bumper fascia upper support. Tighten the bolts to 10 N.m (88 in lbs).
  4. Close the hood.
scientia non olet · About LEMON Manuals