LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 443 (Body Rear End) >> Repair Instructions >> Lock Cylinder Replacement - Rear Compartment Lid (LX5 Engine, 3.5L V6/Steel Lid) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the lock cylinder (2) into the rear compartment lid.
  2. Install the retainer clip (3) to the back side of the rear compartment lid in order to retain the lock cylinder (2) to the rear compartment lid.
  3. Install the rear compartment lid applique. Refer to Compartment Lid Applique Replacement - Rear  .
  4. Install the latch cable to the back side of the lock cylinder.
  5. Install the rear compartment lid trim. Refer to Compartment Lid Trim Replacement - Rear  .
  6. Close the rear compartment lid.
    Fig 1: Installing Lock Cylinder
    G01804056Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals