LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 443 (Body Rear End) >> Repair Instructions >> Fuel Filler Door Release Actuator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the electrical connector to the fuel filler door actuator.
  2. Route the fuel filler door manual release cable through the hole in the fuel filler pocket.
    Fig 1: Connecting Fuel Filler Door Actuator Electrical Connector
    G01804037Courtesy of GENERAL MOTORS CORP.
  3. Install the fuel filler door actuator to the fuel filler pocket.
    Fig 2: Installing Fuel Filler Door Actuator
    G01804038Courtesy of GENERAL MOTORS CORP.
  4. Install the push pins to retain the fuel filler door actuator to the fuel filler pocket.
  5. Install the LH side rear compartment trim panel. Refer to Compartment Trim Panel Replacement - Rear  .
  6. Route the fuel filler door manual release cable through the opening in the LH side rear compartment trim panel.
  7. Close the rear compartment lid.
  8. Close the fuel filler door.
    Fig 3: Locating Fuel Filler Door Actuator
    G01804039Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals