LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 438 (Power Seat System) >> Repair Instructions >> Power Recliner Motor Replacement - Front Seat >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora and 2001 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the recliner position sensor (5) to the recliner motor (4), if equipped.
  2. Install the power recliner motor into the seat back frame.
  3. Slide the recliner rod (2) through the power seat back recliner motor and the recliner assembly.
  4. Install a new push on nut (6) to the end of the recliner rod.
    Fig 1: Locating Power Recliner Motor
    G01803903Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to FASTENER NOTICE in Cautions and Notices.
  5. Install the power recliner motor fastener (1).

    Tighten 

    Tighten the recliner motor fastener (1) to 9 N.m (80 lb in).

  6. Install the wiring harness in the position in which it was removed.
  7. Connect the electrical connector to the power recliner motor and recliner position sensor if equipped.
  8. Install the inner recliner trim cover. Refer to Seat Adjuster Track Cover Replacement - Front  .
  9. Install the inner seat adjuster track cover. Refer to Seat Adjuster Track Cover Replacement - Front  .
    Fig 2: Locating Power Recliner Motor Fastener
    G01803904Courtesy of GENERAL MOTORS CORP.
  10. Install the seat back cover and pad. Refer to Seat Back Cover And Pad Replacement - Front  .
  11. Install the front seat. Refer to Seat Replacement - Bucket  .
  12. Enable the SIR system. Refer to ACTIVATING SYSTEM in SIR.
scientia non olet · About LEMON Manuals