LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 434 (Body Front End) >> Repair Instructions >> Seal Replacement - Hood Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the center rear hood seal to the vehicle by pushing it firmly over the flange.
  2. Use the bends in the flange behind the strut towers to align the seal properly.
    Fig 1: Installing Center Rear Hood Seal
    G01803376Courtesy of GENERAL MOTORS CORP.
  3. Position the outer rear hood seal to the Vehicle.
  4. Install the push-in retainers in order to secure the outer rear hood seal to the vehicle.
    Fig 2: Installing Outer Rear Hood Seal
    G01803377Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals