LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 433 (Wiring Systems (General Information)) >> Repair Instructions >> Relay Replacement (Within An Electrical Center) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the electrical center cover.
  2. Locate the relay. Refer to REAR FUSE BLOCK to locate the electrical center where the relay exists.

    Important: 

    • Always note the orientation of the relay.
    • Make sure the electrical center is secure, as not to put added stress on the wires or terminals.
  3. Using the J 43244  (1) position the tool on opposing corners of the relay (2).
    CAUTION: Use J43244 to pull the relay straight out from the electrical center terminals. The use of pliers or a flat bladed tool could damage the electrical center.
  4. Remove the relay (2) from the electrical center.
    Fig 1: Remove Relay From Electrical Center
    G01802747Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals