LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 433 (Wiring Systems (General Information)) >> Repair Instructions >> Rear Electrical Center or Junction Block Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to FASTENER NOTICE .
  1. Install all the connectors to the rear fuse block and hand start the fasteners.

    Tighten 

    Tighten the fasteners to 6.6 N.m (58 in lbs).

  2. Install the rear electrical center into the base assembly ensuring all the clips engage.
  3. Install the positive battery cable and nut (1).

    Tighten 

    Tighten the nut to 15 N.m (11 ft lbs).

  4. Install the rear seat cushion. Refer to SEAT CUSHION REPLACEMENT -- REAR .
  5. Connect the negative battery cable. Refer to BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PRO .
    Fig 1: Installing Positive Battery Cable Nut
    G01802764Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals