LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 430 (Body Rear End) >> Repair Instructions >> Release Actuator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the lock actuator to the rear compartment lid latch.
    Fig 1: Identifying Release Actuator
    G01756362Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  2. Install the lock actuator to rear compartment lid latch bolts. Tighten the bolts to 6 N.m (53 lb in).
  3. Connect the electrical connector to the lock actuator.
  4. Connect the lock cylinder cable to the lock cylinder.
  5. Close the rear compartment.
scientia non olet · About LEMON Manuals