LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Engine Mechanical - 6.6L (On-Vehicle)) >> Removal & Installation >> Valve Rocker Arm Covers >> Installation (Lower Right)

Installation (Lower Right)

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install gasket in lower valve rocker arm cover. Install bolt grommets in lower valve rocker arm cover. Install lower valve rocker arm cover.
  2. Install 12 bolts for lower valve rocker arm cover. The lower valve rocker arm cover is tightened 2 times in numerical order. Bolts No. 1 and 2 are used to position cover. Tighten lower valve rocker arm cover to 89 INCH lbs. (10 N.m) in proper sequence. Retighten lower valve rocker arm cover bolts to 89 INCH lbs. (10 N.m) in proper sequence. See Figure.
  3. Install injector harnesses. Install injector harness bracket bolts. Install injector wire terminals and nuts to injectors. Connect injector wiring harnesses connectors. Install right upper valve rocker arm cover.
scientia non olet · About LEMON Manuals