LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Engine Mechanical - 6.6L (On-Vehicle)) >> Removal & Installation >> Oil Pan >> Installation (Lower)

Installation (Lower)

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove oil level sensor and retaining clip. Clean lower oil pan. Remove any sludge or other deposits. Clean lower oil pan mating surface. Inspect lower oil pan for dents or distortion.
  2. Inspect lower oil pan mating surface for damage. Replace lower oil pan if any damage is found. Install oil level sensor and retaining clip. Install oil level sensor bolt.
  3. Apply a 1/8" (2 mm) wide bead of Sealant (GM 97720043) to lower oil pan mating surface. Install lower oil pan. Install lower oil pan bolts and nuts.
  4. Connect oil level sensor and install clip. Install crossbar, oil pan skid plate, oil filter, and oil pan drain plug. Lower vehicle. Fill engine with oil.
scientia non olet · About LEMON Manuals