LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Engine Mechanical - 6.6L (On-Vehicle)) >> Removal & Installation >> Engine Flywheel >> Installation (A/T)

Installation (A/T)

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Install flywheel to crankshaft. Install flywheel washer to flywheel. Install NEW flywheel bolts. Install flywheel holding tool to lock flywheel. Tighten flywheel bolts to 58 ft. lbs. (78 N.m). Tighten flywheel bolts 60 degrees using Torque Angle Meter (J-36660-A). Tighten flywheel bolts again to 60 degrees using torque angle meter. Confirm tightening torque is at least to 266 ft. lbs. (360 N.m). See Figure. Install transmission.

scientia non olet · About LEMON Manuals