LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Engine Mechanical - 6.6L (On-Vehicle)) >> Overhaul >> Cylinder Block Assembly >> Piston & Rod Assembly

Piston & Rod Assembly

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Mark piston and rod assembly for installation to original bore. Mark rod and cap in relation to piston. Install piston pin retaining rings.
  2. Properly position ring end gaps around circumference of piston. See Figure. Install piston and rod assembly in bore, with piston crown indent toward outside of engine.
scientia non olet · About LEMON Manuals