Draining Procedure
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora and 2001 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the surge tank pressure cap.
- 1.1. Clean the cap.
- 1.2. Pressure test the cap.
- 1.3. If necessary, replace the cap.
- 1.4. Clean the surge tank filler neck. Inspect the filler neck.
- Remove the front air deflector. Refer to AIR DEFLECTOR REPLACEMENT -- FRONT .
- Open the radiator drain at the bottom of the radiator.
- Completely drain the cooling system.
- If the coolant is dirty, or if there are deposits in the radiator, flush the cooling system before refilling. Refer to Flushing .
- Remove the surge tank. Refer to Surge Tank Replacement .
- 6.1. Clean the outside of the surge tank.
- 6.2. Pour out any fluid.
- 6.3. Thoroughly clean the inside of the surge tank using soap and water.
- 6.4. Thoroughly flush the surge tank with clean water and drain.
- Install the surge tank. Refer to Surge Tank Replacement .
- Close the radiator drain.
- Install the front air deflector. Refer to AIR DEFLECTOR REPLACEMENT -- FRONT .