LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 429 (Engine Cooling System) >> Repair Instructions >> Coolant Heater Replacement - Right (LX5) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora and 2001 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the threaded hole in the engine block with the hole labeled "R" (1) on the right engine coolant heater.
    Fig 1: Aligning Right Engine Coolant Heater
    G01817612Courtesy of GENERAL MOTORS CORP.
  2. Install the right engine coolant heater.
    CAUTION: Refer to FASTENER NOTICE .
  3. Install the engine coolant heater bolt.

    Tighten 

    Tighten the engine coolant heater bolt to 10 N.m (89 in lbs).

    Fig 2: Installing Right Engine Coolant Heater
    G01817613Courtesy of GENERAL MOTORS CORP.
  4. Connect the coolant heater cord (2) to the right coolant heater (4).
    5. Fig 3: Connecting Coolant Heater Cord
    G01817614Courtesy of GENERAL MOTORS CORP.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals