LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 425 (Engine Mechanical - 4.0L (Unit Repair)) >> Repair Instructions >> Starter Motor Installation

Starter Motor Installation

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora and 2001 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. If installing a NEW starter, transfer the cables from the old starter.
  2. Install the positive battery cable to the starter motor stud.
    CAUTION: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the starter motor stud nut.

    Tighten 

    Tighten the starter motor stud nut to 9.5 N.m (84 in lbs).

  4. Install the solenoid wiring harness to the starter solenoid stud.
  5. Install the starter solenoid stud nut.

    Tighten 

    Tighten the starter solenoid stud nut to 3.4 N.m (30 in lbs).

  6. Place the starter motor in position in the engine valley.
    Fig 1: Installing Starter Motor
    G01817352Courtesy of GENERAL MOTORS CORP.
  7. Install the two starter motor retaining bolts.

    Tighten 

    Tighten the starter motor retaining bolts to 30 N.m (22 ft lbs).

  8. Install the knock sensor (1).

    Tighten 

    Tighten the knock sensor (1) to 20 N.m (15 ft lbs).

    Fig 2: Installing Knock Sensor
    G01817353Courtesy of GENERAL MOTORS CORP.
  9. Connect the knock sensor wire lead.
    Fig 3: Connecting Knock Sensor Wire Lead
    G01817354Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals