LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 425 (Engine Mechanical - 4.0L (Unit Repair)) >> Repair Instructions >> Oil Pump Disassemble

Oil Pump Disassemble

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora and 2001 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the drive spacer (7) from the oil pump housing.
  2. Remove the two screws (8) holding the pump housing halves (6, 1) together.
  3. Remove the inner (drive) and the outer (driven) rotors (5) from the housing. Note the orientation of the pump rotors. The outer rotor has one chamfered edge. The chamfered edge must be face-down (closest to the rear of the engine) in the pump body (1).
  4. Remove the oil pressure relief valve (2) as follows:
    1. 4.1. Remove the pressure relief valve cap retaining pin (4).
    2. 4.2. Remove the retaining plug without damaging the O-ring seal.
    3. 4.3. Slide the pressure relief valve spring and piston out of its bore.
    Fig 1: Exploded View Of Oil Pump Assembly
    G01815906Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals