Valve Rocker Arm Installation - Right

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora and 2001 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.

Apply a liberal amount of lubricant GM P/N United States 12345501, GM P/N Canada 992704, or equivalent to the roller (2), pivot pocket and valve slot areas (1) of the camshaft followers.

Fig 1: Identifying Camshaft Followers Lubrication Area
Courtesy of GENERAL MOTORS CORP.

Important: The follower must be positioned squarely on the valve tip so that the full width of the roller will completely contact the camshaft lobe. If the followers are being reused you must put them back in their original location.
Place the camshaft followers in position on the valve tip and SHLA. The rounded head end of the follower goes on the SHLA while the flat end goes on the valve tip.
Clean the camshaft journals and carriers with a clean, lint-free cloth.

Fig 2: Installing Camshaft Followers
Courtesy of GENERAL MOTORS CORP.