LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 424 (Engine Mechanical - 3.5L (Unit Repair)) >> Repair Instructions >> Oil Level Indicator and Tube Installation

Oil Level Indicator and Tube Installation

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora and 2001 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a NEW O-ring on the oil level indicator tube.
  2. Install the oil level indicator and tube by sliding the tube down through the exhaust manifold and fitting the end into lower crankcase hole.
    CAUTION: Refer to in FASTENER NOTICE .
  3. Install the oil level indicator tube bolt.

    Tighten 

    Tighten the oil level indicator tube bolt to 9 N.m (80 in lbs).

    Fig 1: Installing Oil Level Indicator Tube
    G01815614Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals