LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 424 (Engine Mechanical - 3.5L (Unit Repair)) >> Repair Instructions >> Crankshaft and Bearings Installation >> Crankshaft Installation Procedure

Crankshaft Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora and 2001 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the crankshaft sprocket drive pin (1). If necessary, lightly tap the pin in place with a small hammer until it bottoms on the crankshaft.
    Fig 1: Installing Crankshaft Sprocket Drive Pin
    G01815392Courtesy of GENERAL MOTORS CORP.
  2. Gently lower the crankshaft into position in the cylinder block.
  3. Ensure that the crankshaft turns without binding or noise.
    Fig 2: Installing Crankshaft
    G01815393Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals