LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 421 (Power Steering System) >> Repair Instructions >> Steering Gear Cylinder Pipe Assemblies/O-Ring Seals Replacement - Off Vehicle (Magnasteer) >> Disassembly Procedure

Disassembly Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Loosen both cylinder line fittings (1) on the cylinder end of the gear assembly.
  2. Loosen both fittings on the cylinder line assemblies (3) at the valve end of the gear assembly.
    Fig 1: Loosening Cylinder Line Fittings
    G01581802Courtesy of GENERAL MOTORS CORP.
  3. Remove both cylinder line assemblies (1) from the rack and pinion gear assembly (2).
    Fig 2: Removing Cylinder Line Assemblies
    G01581803Courtesy of GENERAL MOTORS CORP.
  4. Remove the O-ring seals (1) from the valve end of line.
  5. Discard the O-ring seals (1).
    Fig 3: Removing O-Ring Seals
    G01581804Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals