Disassembly Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.

To remove the outer tie rod; refer to Tie Rod End Replacement - Outer .
Remove the hex jam nut (2) from the inner tie rod assembly (1).

Fig 1: Removing Hex Jam Nut
Courtesy of GENERAL MOTORS CORP.
Remove the tie rod end clamp (2) from the rack and pinion boot (1).

Fig 2: Removing Tie Rod End clamp From Rack & Pinion Boot
Courtesy of GENERAL MOTORS CORP.
Remove the boot clamp (1) from the rack and pinion boot with side cutters.
Discard the boot clamp (1).

Fig 3: Removing Boot Clamp From Rack & Pinion Boot
Courtesy of GENERAL MOTORS CORP.
Remove the rack and pinion boot (1) from the rack and pinion gear assembly.

Fig 4: Removing Rack & Pinion Boot From Rack & Pinion Gear Assembly
Courtesy of GENERAL MOTORS CORP.