Steering Column Trim Covers - Assemble - Off Vehicle

WARNING: This page is about a different car, the 2002 Chevrolet Monte Carlo and 2002 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 41352 Steering Column Holding Fixture

Install the upper trim cover (2) and secure with the TORX® head screw (1). Tighten the screw to 1.5 N.m (13 in lbs).
If column shift, the shift lever seal must seat correctly in the trim covers.

Fig 1: Steering Column Upper Trim Cover
Courtesy of GENERAL MOTORS CORP.
Install the lower trim cover (1) and secure by using the 2 pan head tapping screws (2). Tighten the screws to 3.5 N.m (31 in lbs).

Fig 2: Steering Column Lower Trim Cover
Courtesy of GENERAL MOTORS CORP.
Remove the steering column from J 41352 .
Install the steering column. Refer to Steering Column Replacement .
Install the steering wheel. Refer to Steering Wheel Replacement .
Install the tilt lever. Refer to Tilt Lever Replacement - On Vehicle .
Enable the inflatable restraint steering wheel module. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .