LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 406 (Seat Belt System) >> Repair Instructions >> Seat Belt Height Adjuster Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the shoulder/seat belt guide adjuster to the vehicle.
    CAUTION: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  2. Install the shoulder/seat belt guide adjuster retaining bolts to the pillar.

    Tighten 

    Tighten the shoulder/seat belt guide adjuster retaining bolts to 52 N.m (38 ft lbs).

    Fig 1: Installing Shoulder/Seat Belt Guide Adjuster
    G01737593Courtesy of GENERAL MOTORS CORP.
  3. Install the shoulder/seat belt guide to the guide adjuster.
  4. Install the shoulder/seat belt guide retaining bolt to the guide adjuster.

    Tighten 

    Tighten the shoulder/seat belt guide retaining bolt to 52 N.m (38 ft lbs).

  5. Install the front door upper pillar garnish molding. Refer to GARNISH MOLDING REPLACEMENT - UPPER PILLAR .
    Fig 2: Installing Shoulder/Seat Belt Guide
    G01737594Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals