LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 405 (Seat Belt System) >> Repair Instructions >> Bracket Replacement - Child Seat Belt Restraint System >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the bracket in the vehicle.
    NOTE: Refer to FASTENER NOTICE .
  2. Apply a thread sealant, GM P/N USA 12345382 Canada 10953489, Loctite 242, Permatex 24200 to the threads of the bolts (2) and also the stud for the bracket nut (1).
    3. Fig 1: Identifying Center Seat Belts Bracket Nut & Bolts
    G01756524Courtesy of GENERAL MOTORS CORP.
  3. Install the bolts (2) to each end of the bracket. Tighten the child seat latch bracket bolts to 42 N.m (31 ft lbs).
  4. Install the bracket nut (1) between the center seat belts. Tighten the child seat latch bracket nut to 42 N.m (31 ft lbs).
  5. Install the rear center seat belts. Refer to Seat Belt Replacement - Center Rear .
  6. Install the rear seat back. Refer to SEAT BACK REPLACEMENT - REAR (NON-FOLDING) or SEAT BACK REPLACEMENT - REAR (FOLDING) .
scientia non olet · About LEMON Manuals