LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 402 (Seat System) >> Repair Instructions >> Seat Replacement - Bucket (All Except Luxury) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the front seat assembly to the vehicle.
    CAUTION: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring the use of thread locking compound or sealant are identified in corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  2. Install the nuts (3) in order to retain the seat assembly to the vehicle.

    Tighten 

    Tighten the nuts to 60 N.m (44 ft lbs).

  3. Connect the electrical connector to the seat adjuster, if equipped.
  4. Connect the electrical connector to the seat belt buckle.
Fig 1: Installing Nuts To Retain Seat Assembly
G01737177Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals