LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 402 (Seat System) >> Repair Instructions >> Seat Cushion Frame Replacement - Rear (Luxury (Y91)) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the seat cushion frame.
    Fig 1: Installing Seat Cushion Frame
    G01737261Courtesy of GENERAL MOTORS CORP.
    CAUTION: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring the use of thread locking compound or sealant are identified in corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  2. Install the bolts that retain the seat back hinges to the seat cushion frame in the locations noted during disassembly.

    Tighten 

    Tighten the bolts that retain the seat back hinges to the bench seat cushion frame to 30 N.m (22 ft lbs).

  3. Install the seat cushion cover and pad.
  4. Install the rear bench seat to the vehicle. Refer to Seat Replacement - Rear Bench (All Except Luxury)  or Seat Replacement - Rear Bench (Luxury Y91)  .
Fig 2: Installing Bolts To Retain Seat Back Hinges
G01737262Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals