LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 401 (Body Rear End) >> Repair Instructions >> Latch Control Handle Replacement - Left Rear Door >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the left side rear door latch handle (4) to the left side rear door.
    CAUTION: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  2. Install the nuts (2) in order to retain the left side rear door latch handle (4) to the left side rear door.

    Tighten 

    Tighten the left side rear door latch handle retaining nuts to 11 N.m (97 lb in).

  3. Install the lock rods to the left side rear door latch handle (4).
  4. Install the left side rear door trim panel. Refer to TRIM PANEL REPLACEMENT - SIDE REAR DOOR .
    Fig 1: Installing Left Rear Door Latch Control Handle
    G01737421Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals