LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Stoplight Switch >> Removal

Stoplight Switch: Removal

WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Before servicing any electrical component, the ignition key must be in the OFF or LOCK position and all electrical loads must be OFF, unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.
  1. Disconnect the battery negative cable.
  2. Disconnect the electrical connector from the stoplight switch. See Fig 1 . Remove the retainer from the brake pedal pin.
  3. Remove the stoplight switch and the pushrod to the power brake booster from the brake pedal pin. Unsnap the stoplight switch from the power brake booster pushrod. See Fig 1 .
Fig 1: Identifying Stoplight Switch Components
G00307720Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals