Removal & Installation
WARNING: This page is about a different car, the 2001 Chevrolet Tracker and 2000 Chevrolet Tracker. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect negative battery cable. Remove fluid. Remove push rod clevis pin. Disconnect clutch fluid line from master cylinder. Remove clutch master cylinder mounting nuts. Remove master cylinder. See Fig 1 .
- To install, reverse removal procedure. Before installation, bleed air from master cylinder by tilting unit. Fill master cylinder with brake fluid and check for leaks. Bleed system and check clutch pedal free play. See BLEEDING .