LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 399 (Interior Trim) >> Repair Instructions >> Garnish Molding Replacement - Left Body Side Upper >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the driver side front door upper pillar garnish molding. Refer to Garnish Molding Replacement - Upper Pillar .
  2. Remove the body side rear upper garnish molding. Refer to Garnish Molding Replacement - Body Side Rear Upper .
  3. Remove the driver side body side front trim panel. Refer to Trim Panel Replacement - Left Body Side .
  4. Pull at the bottom of the garnish molding in order to release the retaining clips.
  5. Pull down at the top of the garnish molding in order to release the retaining clips.
  6. Remove the left body side upper garnish molding from the vehicle.
  7. Inspect the left body side Upper garnish molding for broken or missing retaining clips. Replace the retaining clips as needed.
    Fig 1: Removing Left Body Side Upper Garnish Molding
    G01737359Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals