LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 399 (Interior Trim) >> Repair Instructions >> Garnish Molding Replacement - Body Side Rear Upper >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. Grasp and gently pull down in order to disengage the body side rear upper garnish molding from the retaining clips.
    Fig 1: Disengaging Body Side Rear Upper Garnish Molding
    G01737363Courtesy of GENERAL MOTORS CORP.
  2. Remove the body side rear upper garnish molding from the vehicle.
  3. Inspect the body side rear upper molding for broken or missing retaining clips. Replace the clips as needed.
    Fig 2: Removing Body Side Rear Upper Garnish Molding
    G01737364Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals