LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 397 (Lighting Systems) >> Repair Instructions >> Marker Lamp Replacement - Side (RPO X88/Z88) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the bulb (2) into the socket.
  2. Connect the bulb socket (2) into the side marker lamp.
  3. Install the side marker lamp (3) or the reflector (5) to the radiator grille (1).
    CAUTION: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners to avoid damage to parts and systems.
  4. Install the side marker lamp or reflector retaining screw (4) to the radiator grille.

    Tighten 

    Tighten the screws to 1.5 N.m (13 in lbs).

Fig 1: Installing (RPO X88/Z88) Components
G01736230Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals