Installation Procedure

Important:  To assist in installing the exhaust manifold to the engine, the tabs on a NEW exhaust manifold gasket will hold the gasket and the bolts in place.

1. Sub-assemble the NEW gaskets, the spark plug wire shields, and the bolts to the exhaust manifold.
2. Ensure that the exhaust manifold bolts are held in place by the tabs on the exhaust manifold gaskets.
3. Install the exhaust manifold.
   Fig 1: Identifying Exhaust Manifold Gaskets

   Courtesy of GENERAL MOTORS CORP.
4. Install the spark plugs.
5. Install the spark plug wires to the spark plugs.
6. Install the AIR pipe to the exhaust manifold.
   CAUTION: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fastener requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
7. Install the spark plug wire support and bolts.

   Tighten 

   Tighten the spark plug wire support bolts to 12 N.m (106 in lbs).

   Fig 2: Installing Spark Plug Wires To Spark Plugs

   Courtesy of GENERAL MOTORS CORP.
8. Install the EGR valve inlet pipe to the exhaust manifold.

   Tighten 

   Tighten the EGR valve inlet pipe exhaust manifold nut to 30 N.m (22 ft lbs).

9. Install the catalytic converter assembly.
   Fig 3: Installing EGR Valve Inlet Pipe

   Courtesy of GENERAL MOTORS CORP.
10. Install the fender wheelhouse extension (1).
11. Install the left front tire.
12. Lower the vehicle.
    Fig 4: Installing Fender Wheelhouse Extension

    Courtesy of GENERAL MOTORS CORP.
13. Connect the ECT gage sensor electrical connector.
14. Install the engine cover.
    Fig 5: Connecting ECT Gage Sensor Electrical Connector

    Courtesy of GENERAL MOTORS CORP.